For monitoring various parameters, one often needs a dedicated signal conditioner with or without display. Very high frequency response signal amplifiers with frequency response of 1MHz or 500KHz or 200KHz, 100KHz or 10KHz for inputs from Quarter, Half or Full Strain Bridges, sensors, accelerometers, voltages etc..

Plain "ANALOG-IN-ANALOG – OUT kind".

Signal Conditioner with digital display with or without analog voltage output or 4 – 20 mA output are also available. These Readouts have built-in sensor excitation source for the sensor. Models are available that can be networked.

Microprocessor based indicators can be interfaced with computers, can be programmed to display in different engineering units of the same parameter (such as psi, kg/cm2, pa or kpa or mpa etc.), can be programmed with several calibration curves to let such indicator be used as a dedicated indicator say for 4 different load cells.

Individual Indicators for Strain, LVDT, Load Cells, Pressure Cells etc. in low cost versions are also available